Snap and Go Plastic Mop Handle, 54”

Snap and Go Plastic Mop Handle, 54”

Pro Loop Cotton Rayon Mophead

IDEAL FOR WASHING OR FINISHING
Ideal for washing and floor finishing, the looped-end yarn makes this mop last 8 times longer than conventional cut-end mops.

From: $7.56 To: $9.89

Availability: In stock
SKU
1008
Select Size Stock SKU Unit Price
Small
In Stock
1006-1
$7.56
Medium
In Stock
1007-1
$8.70
Large
In Stock
1008-1
$9.89
Total
Great solution for
Constructed with cotton/rayon blend, the Pro Loop is ideal for use to wash or finish floors. With looped-end design and tailband, productivity is increased. You can expect to receive wider floor coverage and cleaning of an area, 2-3 times faster in half the time. The design will not tangle and when compared to traditional string mops, it is more suitable for laundering. Break-in prior to use for floor cleaning is necessary. Immerse mop in a mop bucket filled with diluted neutral floor cleaner solution and a water temperature of 49 o C - 60 o C (120 o F - 140 o F). Break-in prior to use for floor finishing is not necessary however, if preferred, wet mop with water and wring out completely so it will not absorb too much finish. Colour coded narrow headband easily identifies size and use for mop. The Pro loop is the best choice in value for a very good quality, all around looped end wash or finish mop.
Product Tips
1
Always hang your mop in a tool holder to help prevent marks and damage to walls.
2
Rinse and wring out mop after each use and hang in a well-ventilated area to air dry and help prevent mildew.
3
Discard and replace worn mop heads to reduce cleaning time.
4
Strong cleaning solutions (bleach, caustics, etc) can be break strands shortening the life of your mop.
5
Cutting-in will eliminate splashing walls and baseboards which will have to wiped by hand, an extra step.
6
If using mop to apply finish, line mop bucket with garbage bag to save clean-up time.
7
Wet mop with water and wring out completely so it will not absorb too much finish.
Instructions

Always place wet floor signs in appropriate areas.

Cutting-in

1. Always mop floor edges and corners keeping mop parallel to the wall.

2. This controls dirty build-up in corners and along edges.

3. It also eliminates splashing walls and baseboards that will then require hand wiping, an extra step.

Mopping

1. Always “cut-in” first.

2. Mop floor area using a figure 8 pattern.

3. Be sure to overlap each pass.

4. Keep the heel of the mop to the floor.

5. Use both sides of the mop. To turn over, keep the mop on the floor and gently roll over to avoid splashing walls and baseboards.

6. Swing mop from side to side using shoulder muscles. Hand and arm muscles will guide the mop.

Finishing

1. Line mop bucket with garbage bag for faster clean-up.

2. Place appropriate amount of finish in bucket to do the job.

3. Immerse mop and wring slightly (mop should not be dripping). Wring slowly to prevent foam.

4. “Cut-in” along edges of a small area. Fill in area with a figure 8 pattern.

5. On the first coat, keep 6” away from the walls.

6. The second coat should be applied to the edge of the floor to eliminate lap marks.

7. Continue to the next small area. “Cut-in” and fill in work into the still damp finish of previous area to avoid lap marks.

Specifications
SKU
1008
Country of Manufacture
N/A
Case Quantity
1
Weight (kg)
N/A
Colour
N/A